From 3d5e3ac72b843d102ec750e524c66a294f107691 Mon Sep 17 00:00:00 2001
From: alex <alex@pdp7.net>
Date: Fri, 20 Jun 2025 18:12:28 +0000
Subject: [PATCH] Add instructions to connect remote hosts

---
 linux/remote-networking.md | 24 ++++++++++++++++++++++++
 1 file changed, 24 insertions(+)
 create mode 100644 linux/remote-networking.md

diff --git a/linux/remote-networking.md b/linux/remote-networking.md
new file mode 100644
index 0000000..dac3508
--- /dev/null
+++ b/linux/remote-networking.md
@@ -0,0 +1,24 @@
+# Remote networking
+
+If you can create a pipe between two hosts (using SSH, for example), you can use VDE (Virtual Distributed Ethernet) to connect the two hosts over a virtual network.
+
+You need the following programs on both hosts:
+
+* `dpipe` and `vde_plug` (on Debian, use the `vdeplug` package)
+* `vde-switch` (on Debian, use the `vde-switch` package)
+
+Run `vde_switch -t tap0` as root on both hosts.
+This command creates a virtual switch connected to `tap0`.
+
+Use the `dpipe` command to connect two instances of the `vde_plug` command running as root on both hosts.
+
+```console
+$ dpipe sudo vde_plug = ssh root@remote vde_plug
+```
+
+Then bring the `tap0` interface up and configure IP addresses on both hosts.
+
+```console
+# ip link set tap0 up
+# ip addr add $IP/$NETMASK dev tap0
+```
-- 
2.47.3